You have addet 0 items to your cart totaling $ 0.00
 
 
Categories
Site Map
Specials
Order Tracking
Home Security
Keypads
Remotes & Receiver Kits
Replacement Parts
Safety Sensors

What's New
 
1. Sears Craftsman Liftmaster garage door opener wireless keypad model 977LM Security+
2. Genie GIRUD-1T Universal Dual Frequency Conversion Kit
3. Chain retainer bracket 1984-1989 (Not Shown)
4. Liftmaster 41AB050-2 Receiver Logic Board Assembly for WD822KD & HD600
5. Chamberlain 41R0370-15 Cover
 
 
Top Sellers
 
1. Genie 36179R.S Replacement Carriage Assembly
2. Skylink Garage Door Opener Universal Keypad (model 89) for models up to 2003
3. Replacement Bell Wire
4. Replacement Carriage Assembly for Genie Screw Drive Garage Door Openers 20414R
5. Stanley Garage Door Opener Carriage Assembly-Part # 49223
 
Shopping Cart
 
 Qty 0
 Total($) 0.00
 
 
     
Linear 1-Channel Digital Isolated Relay Output Receiver DXR-701 (DXR-701)

Linear 1-Channel Digital Isolated  Relay Output Receiver DXR-701

While Supplies Last

The Model DXR-701 is a digital receiver with an isolated relay output designed for use with Linear’s DX Format transmitters. This receiver can be used in a variety of remote control applications. When the receiver detects a signal from a transmitter programmed into its memory, the relay output activates. The relay has four optional output configurations.

In a typical installation, the receiver is connected to an alarm control panel, door strike, camera, high current relay or some other device. A transmitter is used to activate or control the device. The receiver should be mounted with the supplied mounting bracket indoors or outdoors inside a weather resistant non-metallic housing.

The digital DX code format features over a million possible codes. The DX transmitters are precoded at the factory to unique codes, so no field coding is required. Receivers must be programmed to the transmitter’s code before system testing and operation. Up to 32 transmitters can be programmed into the receiver’s memory. The memory is retained, even without power.

The unit can be powered from a 11-17 VDC or 12-16 VAC power source. The relay’s normally open and normally closed contacts can switch up to 1 amp at 24 volts AC/DC.

Manual

Features
  • 32 transmitter capacity
  • RF activity indicator
  • Quick-learn programming
  • Operates on 11-17 VDC or 12-16 VAC power
  • One channel
  • DX format
  • One form "C" relay output
  • One Amp contact rating @ 24 Volts AC/DC
  • Selectable relay activation time
  • Current consumption: 25 mA standby, 60 mA operating @ 12 VDC
  • RF frequency: 315 MHz
  • 5.5" W x 4.0" H x 1.25" D
Compatible Remotes
  • Linear 1-Button, 1-Channel Mini Remote Control DXT-41
  • Linear 2-Button, 3-Channel Mini Remote Control DXT-42
  • Linear 2-Button, 1-Channel Handheld Transmitter DXT-21
  • Linear 3-Button, 4-Channel Handheld Transmitter DXT-23
  • Linear 5-Button, 8-Channel Handheld Transmitter DXT-25
  • Linear 1-Button, 1-Channel Pendant Transmitter DXT-61A
Other Compatible Products
  • Linear Home Security Passive Infrared Motion Detector DXT-54
  • Linear Door/Window Home Security External Contact and Glass
    Break Sensor DXT-31
  • Linear Battery Powered Cash Drawer Bill Trap DXT-81
  • Linear Home Security Supervised Photoelectric Smoke Detector DXS-72
Operating Frequency: 315 MHz
Data Format: DX format
Number of Codes: 1,048,575
Channels: one channel
Measured Range: 700 feet in one quadrant with DXT-21 transmitter; 500 feet in open air (four quadrant test)
Operating Temperature: 32° to 140°  F (0° to 60° C)
Sensitivity: -95 dBm (typical)
Number of Stored Transmitter Codes: 32 per receiver
Receiver Output: For "C" relay contact, 1 amp, at 32 VDC per channel
Field Selectable Receiver Output Modes: Momentary, four seconds (factory set)
Momentary, one second
Flip-flop toggle
latch, 2-Channel
MODE BUTTON (one per channel)
Learn Mode: Press and release to enter learn mode
Transmitters
Learned:
Press and hold for five seconds after the last LED flash to delete all transmitters on an associated channel
Erase Memory: Press and hold for five seconds after the last LED flash to delete all transmitters on an associated channel
Clear Latch: Press and release
Clear Low
Battery:
Press and release mode switch on channel 2 (DXR-702 only) to clear low battery
LED INDICATOR
Steady: Indicates "learn" mode
Flashing: Indicates number of transmitters learned on the selected channel
RF Activity: Blinks synchronously with detected RF activity
Antenna: Wire lead
Input Impedance: 75 Ohm - 2:1 VSWR
Operating Voltage: 11 to 17.5 VDC
12 to 16 VAC
Current: 25 mA at standby at 12 VDC
60 mA in alarm at 12 VDC
Connectors: Screw terminal,+,-, with N/O, N/C, and common per receiver channel
Dimensions: 5.5 in L x 1.25 in W x 4 in H (140 x 32 x 102 mm), excluding antenna
Accessories: Mounting bracket, screws, and anchors (supplied)
Regulatory Requirements: FCC and DOC


Related Products :
Safety and Repair > Home Security > Linear > Wireless Receivers

Product Reviews :
Write a review
  
Ready To Order?

Our Price: $48.00

Item in stock!

 

Email a Friend

Product Inquiry

Verified by VISA

Knowledge Base
Non Reversing Garage Door Openers: A Hazard
Meeting the Demand for More Intelligence and Power
Military Radio Signals are Jamming Garage Doors
Safety Tips for Preventing Injuries
The Basics of Access Control
How Garage Doors WorK
Garage Door Glossary
Chamberlain Parts Breakdown and Schematics
LiftMaster Parts Breakdown and Schematics
Genie Opener Parts Breakdown and Schematics
 
Related Articles
Master Lock® smartTOUCH™ Garage Door Opener To Be Featured on Popular Home Improvement Show
Security Tips for Automated Garage Doors
New Garage Doors Add Curb Appeal
Accessorize, Baby! Boost Profits with New Safety Products
SkyLink Group Manufactures OTODOR Automatic Swing door Opener
Door Industry Grapples with Military’s Siege of 390MHz
Skylink Reveils New GDO Safety Solution
Garage Door Opener Accessories
Garage Door Opener Safety Buying Guide
Military Signals May Jam Garage Door Openers
Genie Garage Door Openers
 
 
 
     
       
  © 2010 Garage-Safety.com. All rights reserved. Garage-Safety, Garage-Safety.com and the logo design are trademarks of Mega Access Controls, Inc.